News‎ > ‎

In Car Decoder v2 PCB Layout Complete

posted Nov 7, 2008, 11:28 AM by Bryan Thomas   [ updated Jan 4, 2009, 6:49 AM ]
We have completed the initial PCB layout for the In Car Decoder. The final board is quite small for the amount of current that it can handle. We had to use 8mil spacing and 20mil vias to get everything to fit. Check for the latest schematics, pcb and gerber files on the Files page. After we confirm and double check that the parts fit with the old print on paper method, we will get a few samples and start initial testing.



Size:
  • 20 mm x 35mm
Electrical:
  • 4 Amps Continuous, 8 Amps Peak
  • Up to 16 Volts
Features:
  • AVR 8 bit processor
  • Integrated H-Bridge controller
  • ICSP header on the board
  • Full bridge rectifier


Comments